ryan JR Sodcutter 544844D, Руководство по обслуживанию и запасным частям

Страница: 14 / 38

GB-12
Jr.
Sodcutter
SERVICE
DRIVE WHEEL CHAIN SPROCKET SHAFT
1. Follow steps 1 thru 7 in drive chain removal
section.
2. Remove master link and remove chain from top
sprocket.
3. Remove both drive wheels and axle keys.
4. Remove seal in case and snap ring retaining
bearing in case.
5. Install axle nut on end of shaft, opposite the side
of snap ring previously removed.
6. Using a soft hammer (lead, brass, etc.), drive
shaft out of case. Sprocket can now be
removed by lifting up on chain.
7. Top sprocket and chain should be checked for
wear and replaced if necessary.
8. Reassemble in reverse procedure using new
seals and gaskets.
ADJUSTING BLADE ANGLE
1. Loosen blade angle control locking lever F and
move H-frame forward or backward until blade is
at desired angle of pitch.
2. Tighten blade angle control locking lever F.
SIDE ARM
DRIVE
WHEEL
BLADE
BOTTOM
BLADE
ANGLE
(Pitch)
BLADE ANGLE (PITCH)
Under normal operating conditions, blade angle
is minimal (blade bottom is flat). In extremely
hard soil or when cutting with a dull blade, the
blade may want to ride out of the ground. It may
then help to adjust blade angle downward (see
Adjusting Blade Angle above). A short trial run
will indicate which is the best blade angle.