ryan JR Sodcutter 544844D, Руководство по обслуживанию и запасным частям

Страница: 10 / 38

GB-8
Jr.
Sodcutter
SERVICE
When replacement parts are required, use
genuine RYAN parts or parts with equivalent
characteristics, including type, strength and
material. Failure to do so may result in product
malfunction and possible injury to the operator
and/or bystanders.
Carbon monoxide present in the exhaust is an
odorless and deadly gas. Never start or run the
engine inside where exhaust fumes can collect.
Provide enough fresh air to keep fumes from
getting too strong.
When replacing engine, be sure to replace
sound level warning decal (Part No. 524538).
Any warning decal that becomes illegible should
be replaced immediately.
840697
STOP engine and disconnect spark plug wire
before servicing or making adjustments to unit.
The preceding decal shows what could happen
if the engine is not stopped or disabled before
removing safety covers. Hands may become
entangled in moving belts, gears, chains or other
parts.
Use adequate lifting device (i.e., hoist, fork lift,
etc.) to raise unit.
Use adequate supports when unit is raised for
servicing.
Wear protective eye equipment when using
hammers, chisels and punches.
BLADE SHARPENING
1. Hand file bottom blade at 45 O angle until no flat
remains.
2. To keep cutting edge less than 1/16" on 45 O
angle, grind milled surface back at 15 O to less
than 1/16".
3. Hand file side blades at 45
O
until no flat remains.
4. To keep cutting edge less than 1/16" on 45
O
angle, grind milled surface back at 15
O
to less
than 1/16".
THIS
1/16"
Maximum
45
O
15
O
FILE
DIRECTION
SURFACE
SMOOTH
(No Burrs)
BOTTOM BLADE
MILLED
EDGE
FILE
DIRECTION
1/16" MAX
THIS SURFACE SMOOTH
(No Burrs)
FILE
DIRECTION
SIDE BLADE