RVE Merak E750, Руководство по сборке

Страница: 33 / 56

RVE MERAK E750 - ASSEMBLY INSTRUCTIONS
TAIL ROTOR ASSEMBLY AND INSTALLATION (5-7)
Install the tail blade holders shafts into
the hub with soft threadlocker.
Use a 6 mm one-way wrench for
tightening them.
Install the M3 threaded ball in each blade holder.
Complete the assembly as shown in the picture.
The thrust bearing must be greased, then assembled
with its bigger id bearing race inside and the shorter
one outside. Fix it with the M3 x 8 mm screw using
soft threadlocker.
***Recommended tightening torque:
0.8 Nm for the M3 threaded balls
1.2 Nm for the M3 x 8 mm screws
33