Para UV
The LED
strip
is only suitable for installation in dry
indoor rooms.
Risk of electric shock!
Be sure to have a professional electrician complete
in stallation. There is no warranty coverage for any lights
installed without observing european safety directives.
Caution!
Only connect the
LED strip to a suitable
power supply (24 V DC).
Only operate when completely unrolled.
Connect
LED strips in parallel.
SCOPE OF DELIVERY:
Para UV
1 x 5 metre LED board
TECHNICAL DATA:
power supply 12 V power supply with constant
output voltage
power 96 W
current strength 8 A
beam angle 120°
quantity LED 1200
length maximum 5 metres per connection
dimensions 5000 x 16 mm
bending diameter 40 mm
safety class 3 - low voltage protection
suitable for indoor use only
very light - profile necessary
the
LED strip needs an
additional cooling element and
sufficing air ventilation
compliant with the applicable
european CE directives
Please refer to the respective article on www.rutecprojekt.de
for complete technical data!
MOUNTING:
Risk of electrik shock!
Switch off the voltage before installation. Make sure that
the voltage can not be accidentally switched on again.
Mounting
Para UV:
Caution!
In the case of current-carrying surfaces, apply an insulating
layer between the
LED board and surface. Surfaces must be even, free of dust
and grease and dry.
1. Prepare the surface.
2
Shorten the LED board if necessary (Fig. 1).
3. Remove the protective film and press the LED board on with
light pressure, but do not press directly on the electronic
components.
4
Connect the LED board to the power supply.
SHORTENING THE LED STRIP:
Risk of electrik shock!
Always disconnect the mains plug before shortening.
The LED-Strip can be cut every
three
LEDs (per row) or
separated after 2.5 cm each (fig. 1).
fig. 1
Caution!
With soldered connections note that the soldering
tem perature is 260° C and the soldering duration a
maximum of 10 seconds per soldering point.
Caution!
Only use neutral cross-linked silicon (never use silicon
which includes vinegar!).
Disposal
Dispose of electrical and electronic equipment in an
environmentally friendly manner. Please contact your
local council for further information.
1. Cut the LED board at the marked point.
CONNECTING LED BOARDS:
With direct connector:
To connect two LED boards, use a direct connector.
With power supply connector:
To connect an LED board to a power supply unit, use a power sup-
ply connector.
fig. 2
fig. 3
1.
Do not remove
the adhesive strip at the connection point.
2. Pull out the fastener of the feed connector (fig. 2).
3. Plug the feed connector onto the end of the LED board
(observe the polarity) and close the lock (fig. 3).
ParaUV_BA_PHH996_06/2022
Para UV
Carl-Zeiss-Str. 15
28857 Syke
rutec
Projekt
G
G
