3
e-z LOG products
E-Z 45° LOG TENON CUTTER
The original E-Z 45° Log Tenon Cutter cuts a
45° tapered shoulder at the ends of logs and
branches. The cutter arms are made from
aluminum. The shaft, guide bar and adjustment
bar are made from steel.
The E-Z 45° Log Tenon Cutter uses one,
double-sided blade to cut a log tenon. A spare
blade is also included and stored on one of the
cutting arms. When one side of the blade gets a
little dull, simply use the included hex key to flip
it over to the sharp side. It is like having four
blades included with your order. Replacement
blades are available at our website,
.
more information about the blades.
The E-Z 45° Log Tenon Cutter will fit into any 1/2” drill, but we do
recommend using a drill with a side handle for extra wrist
support.
A 3/8” pilot hole must be drilled into the end of the log prior to
cutting a tenon. a 3/8” drill bit is included with your order. The
pilot hole guides the cutter to produce a perfect tenon.
To set up your tenon diameter, you simply loosen the screws
on the adjustment bar. You then slide the cutter arms so that
the edge of the cutting blade is the same size as whatever bit you will be using to drill your
mortise. It is just that simple.
Please see the
section of this manual for more technical details, and be sure
to check out the
section to speed up your project.
E-Z 90° LOG TENON CUTTER
The E-Z 90° Log Tenon Cutter cuts flat,
90° tenon shoulder, and uses two,
double-sided cutting blades, one mounted
on each cutting arm. The blades are
double-sided, so when one side gets dull,
simply use the included hex key to flip
them over to use the sharp side.
Replacement blades are available at our
website,
