RUSTA 623514700101, Руководство пользователя

Страница: 5 / 52

5
BURNERS
FREQUENTLY ASKED QUESTION
Why is there no seal between the burner and valve?
Answer: In order for the gas to get the right combustion at the burner, it must be mixed with
oxygen. This happens in the joint between the valve and the burner. The joint must not be
sealed. If you do, the combustion will deteriorate.
LIGHTING INSTRUCTIONS
1. Open the hood and make sure the burner is in the off position.
2. Connect the regulator to the gas cylinder. Open the gas cylinder’s valve to release the
gas.
3. Press any of the knobs with a lightning symbol on the barbecue and turn anticlockwise
towards the HI position. This releases the gas and generates a spark.
4. If the burner does not light within 5 seconds, turn the knob to the closed position and
close the valve on the gas cylinder. Wait 5 minutes, and then redo steps 2 and 3.
5. When the barbecue is lit, turn the knob between HI and LO to adjust the heat.
6. To switch it off, turn the gas cylinder’s valve to the closed position and then turn the
knob on the barbecue clockwise to the closed position.
CLEANING AND MAINTENANCE
• Allow the barbecue/all parts to cool fully before cleaning them.
• Check to make sure the fuel supply from the gas cylinder has been turned off.
• Clean the interior and exterior of the barbecue thoroughly and regularly.
• The grease/oils that collect in the bottom of the barbecue, the drip plate and heat distri-
butors must be cleaned from the barbecue regularly, otherwise there is a significant risk
of the fat catching fire.
• If the barbecue is used in especially corrosive environments, for example, by the sea, it
is even more important to clean the barbecue often. Salt and moisture will break down
the protective outer layer of the barbecue, which can result in surface rust.
CLEANING THE EXTERIOR OF THE BARBECUE
• Wash the outside of the barbecue with a soft sponge, a mild detergent and water. Rinse
with clean water and let it dry. Do not use abrasive cleaners.
• If the painted steel is scratched or damaged and has started to rust, brush the surface
with a steel brush, scrape it and then paint with anti-rust primer. This should be done
as soon as the damage is discovered, as scratches in the paint make the furniture more
susceptible to rust.
Valve
Burner hose
Gas
Oxygen