Russound X5 Controller Streamer Amplifi er Installation Manual
45
X5 LED DIAGNOSTIC CHART
Reset Button
Note:
use non
conductive tool to
depress the button
IR Learning
IR Talkback
System On LED
System Status LEDs
Yellow Green Red
Blue
Booting
Solid yellow LED.
Access Point
Solid green LED and solid yellow LED. Yellow
LED may initially blink for a short period of time.
Ready
Solid green LED.
Zone On
Solid blue LED.
Firmware Update
Blinking green LED
Firmware Update During Initialization
Solid yellow, blinking green LED.
Network Error
Blinking yellow LED.
Access Point - Error
Solid green LED with yellow LED blinking continu-
ously. May require reinitializing access point mode.
Error Codes
All LEDs can be used to display various error codes.
Error codes are derived from the number of times
each LED blinks.
X5 Bottom Panel
Reinitializing Access Point Mode
Depress the button on the bottom panel for
2 seconds. Yellow and green LEDs will blink
6 times then go solid. If the Ethernet cable is
connected, the Red LED will blink as a warning
that the X5 will reboot in wired-ethernet mode.
See page 5 “Connecting to a wireless network”
Factory-Initialization
Depress the button on the bottom panel for
more than 10 seconds. The red LED will go solid
while the X5 is initialized to factory defaults.
The device will then enter Access Point mode.
