18
Russound A-C68 Installation Manual
KEYPAD TO SPEAKER CONNECTION
The speakers in each room are connected to the A-BUS keypad using 4-pole
screw down terminals.
NOTE:
An 8 Ohm minimum speaker is required for each amplified output.
Pull the speaker wire conductors apart so they’re separated for the first two
inches from their ends.
Using a wire stripper, remove 1/4 inch of insulation from each conductor.
Twist the strands in each conductor into tight spirals.
1.
2.
Insert the speaker wire conductor into the appropriate Speaker Out screw-
down terminal opening, matching channel and polarity for all four wires.
Tighten the connection for each conductor.
NOTE:
Use caution when connecting speaker wires, as shorting between
terminals will cause damage to the digital amplifier and void the warranty.
3.
A-K5L (back)
Screw down speaker
cable connector
Speaker cable
8-ohm speakers
HUB
UPGRAD
E
NOTE:
Use
caution when
connecting speaker
wires, as shorting
between terminals
will cause damage
to the digital
amplifier and void
the warranty.
