Russell Hobbs Supreme Steam 23393, Инструкция по эксплуатации

Страница: 5 / 8

5
DRY IRONING
You can dry iron by just not pressing the steam button, but if you want to make sure you don’t press it
accidentally, then you should iron with an empty reservoir. You can do your dry ironing first, then switch
off, fill the reservoir and do your steam ironing.
VERTICAL STEAMING
Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
•
Check that there’s adequate ventilation behind the fabric, otherwise moisture may build up, causing
mildew.
• Check that there’s nothing behind the fabric that may be damaged by the steam.
• Check that pockets, turn-ups, and cuffs are empty.
1. Check that the temperature control is at
S
or higher. Wait till the thermostat light goes out.
2. Wait until the steam light (
l
) goes out before steam ironing.
3. Hold the iron close to (but not touching) the fabric. Hold it well away for delicate fabrics.
We recommend using the steam trigger to produce steam for smaller areas, as it gives you better control.
LOW WATER
Your iron will beep continuously and the empty reservoir light j will come one when the reservoir needs
refilling.
AFTER USE
1. Put the iron on top of the base unit and turn the temperature control to
•
.
2. Press the
C
button and unplug the base unit.
3. Empty the reservoir.
4. Let the iron cool down completely before cleaning it, moving it, or storing it away.
5. The steam pipe can be wrapped around the groove in the base unit.
6. Coil the mains cable and place it in the cable storage area.
CARE AND MAINTENANCE
1. Unplug the base unit, and let the appliance cool down fully.
2. Wipe outer surfaces with a damp cloth. If necessary, use a little washing-up liquid.
3. Remove spots from the soleplate with a little vinegar.
4. Take care not to scratch the soleplate.
ANTI-SCALE CARTRIDGE
The life of the anti-scale cartridge depends on the frequency of use and the hardness of the water in your
area. It should last for about 100 uses in a soft water area.
1. Remove the reservoir by pulling it away from the body of the steam generator using the grip on the
front of the reservoir (FIG A).
2. Pull the old filter cartridge out of its recess in the reservoir. When you remove the anti-calc cartridge
note its orientation before fitting the replacement because it will only fit correctly one way round.
Refit the new cartridge (FIG D) then replace the reservoir into the base unit.
REPLACEMENT ANTI-SCALE CARTRIDGES
1. Have the appliance
Model Number
to hand, as we won’t be able to help you without it. It’s on the
rating plate (usually underneath the product).