Russell Hobbs Supreme Steam 23393, Инструкция по эксплуатации

Страница: 4 / 8

4
FILLING/REFILLING
• Don’t add anything to the water and don’t use water with anything added to it. When the water is
converted to steam, chemicals, perfume, and other additives will coat the inside of the steam
chamber, shortening the life of the iron.
1. If your iron is plugged in and switched on when you remove the reservoir it will beep until you replace
the reservoir. To avoid this you, switch off (
C
) and unplug the iron before filling.
2. Remove the reservoir by pulling it away from the body of the steam generator using the grip on the
front of the reservoir (FIG A).
3. Fill the reservoir to the
max
mark. Do not exceed the
max
mark.
4. Refit the reservoir into the base unit.
PRELIMINARY SETTINGS
1. Put the iron on top of the base unit.
2. Put the plug into the power socket (switch the socket on, if it’s switchable).
3.
Press the
C
button to switch the iron on. Your iron will beep and the power light will come on.
4. Turn the temperature control to bring the setting you require next to the mark. The thermostat light
will come on and your iron will heat up.
5. It’ll go out when the soleplate reaches the temperature set by the temperature control, then cycle on
and off, as the thermostat works to maintain the temperature.
6. Use the steam control to select the amount of steam you want (
l
= low,
h
= high).
7. The steam light (
l
) will light up until the iron is ready to produce steam. Wait until it goes out before
steam ironing.
TEMPERATURE SELECTION GUIDE
1. Check for textile care symbols (
i j k l
)..
2. Iron fabrics needing low temperatures first, then those that need medium temperatures , and finish
with those needing high temperatures (or max).
3. Turn the temperature control to bring the setting you require next to the mark.
If the instructions on the fabric label differ from this guide, follow the instructions on the label.
L
abel marking
Dot setting
j
cool – nylon, acrylics, polyester
•
k
warm – wool, polyester mixtures
• •
l
hot – cotton, linen
• • •
/ max
i
do not iron
If the soleplate is at a lower temperature that the one you’ve set, the thermostat light will come on, to let
you know that the soleplate is heating up.
When the soleplate reaches operating temperature, the thermostat light will go out, then cycle on and off
as the thermostat works to maintain the temperature
STEAM IRONING
1. Set the temperature control to
S
or higher – otherwise the steam might condense on the soleplate,
giving you water instead of steam.
2. Use the steam control to select the amount of steam you want (
l
= low,
h
= high). Wait until the
steam light (
l
) goes out before steam ironing. The steam light will cycle on and off during steam
ironing.
3. Squeeze the steam trigger to produce steam, release it to stop.