Installation
Adjusting the bottom cover
When opening the shrink package, you will find a calcium
plastic board which is laid on the top of washing machine as
shown in fig.1.The board is used for reducing noise by passing
it under the cabinet when setting as shown in fig.2.
Dismantle the transportation bolts
The transportation bolts are designed for clamping anti-
vibration components inside of the washing machine during
the transportation process and try to ensure the unit is
protected during transportation.
1. Remove the back cover by removing the 3 screws holding it
in place.
2. Remove the three bolts on the rear side and take out the
synthetic stabilisers from within the machine.
3. Replace the back cover (please note that you may have to
hold the back cover in place by holding the vents on the back
cover).
4. Fill the holes left by the bolts with blanking plugs.
Note:
1. When replacing the back cover, ensure it is positioned in the
same way that it was originally removed.
2. Keep the transportation bolts and synthetic stabilisers in a
safe place for later use.
Adjusting the height of the washing machine
There are adjustable feet attached to the bottom of the washing machine. Before use, they
should be adjusted so that the machine is level - this will minimise vibrations and noise
during use, as well as reducing wear and tear.
We recommend using a spirit level to level the appliance - the floor that the washing
machine is put on should be as stable and flat as possible.
For Customer Services, Spare Parts & Warranty Information please call
0845 683 8717
-6-
