8
9
HEPA EXHAUST FILTER
The HEPA exhaust filter is located at the back of the vacuum cleaner.
• Push down the top locking clip on the exhaust filter cover and
pull out.
• Grasp the HEPA exhaust filter clip whilst pushing down and pull
outwards.
• Clean the HEPA filter with warm soapy water and rinse, allow to
dry thoroughly before reinstalling.
• Insert the HEPA filter back into the vacuum by aligning the two securing clips with the
recessed ledge in the back of the vacuum and the filter seal facing toward the vacuum.
Add snap cover back in place. Or replace with a new filter and snap cover back in place.
NOTE:
After a period of time the filter will look worn, contact consumer service for replacement.
MOTOR INLET SPONGE FILTER
The motor inlet sponge filter is located at the top of the housing
directly behind the dust bin.
• To access this filter, remove the dust bin.
• The motor inlet sponge filter is in the cavity near the top of
the unit.
• Grasp the sponge filter and pull out.
• Clean the sponge filter warm soapy water, rinse and allow to dry thoroughly before
reinstalling.
• Insert the sponge filter back into the cavity and refit the dust bin or replace with a new
filter.
BLOCKAGES
If the cleaner starts to get noisy and you start to lose suction there is possibly a blockage.
• Switch the power off and remove the plug from the wall power outlet.
• Spread some newspaper or an old towel on the floor to avoid making a mess.
• If you are using one of the tools, remove and check it first.
• Remove the hose and check it – leave it disconnected until you have completed the next
steps.
• Remove the dust bin and check the inlet for any blockages.
• If there is a blockage, try and remove it with your hands. Do not use anything sharp.
• Check all the filters, then reassemble.
NOTE:
If you have not cleared the blockage following these steps, please ring customer service.
NOTE:
This vacuum cleaner is equipped with an overheat protection system. If for some reason
your vacuum overheats, the motor will turn off. Should this occur, turn the switch off and unplug
the vacuum from the wall outlet. Allow the motor to cool for a minimum of 30 minutes prior to
re-starting the unit. To prevent overheating make sure that the filters and the dust bin are clean.
