Use the included 5mm Allen wrench to loosen and remove
the two screws.
FOR TRUSS MOUNTING: Secure the U-Bracket to the
bottom of the PTX using the two 5mm screws previously
removed, and tighten with the 5mm hex wrench.
FOR TRIPOD/STAND MOUNTING: Secure the Tripod
Mount to the bottom of the PTX using the two 5mm
screws previously removed, and tighten with the 5mm hex
wrench.
Connecting your Camera to the Tilt Plate
Most cameras have a ¼ x 20 thread for mounting on
tripods and stands. Use the included ¼ x 20 x ½
thumbscrew (with plastic washer) to mount your camera
of choice to the tilt plate.
Shown here is the bottom of the Blackmagic Micro Studio
Camera 4K …
and the bottom of the Canon XA25 with a single threaded
hole.
Some cameras, like the AJA RovoCam and Marshall CV
models, have threaded mounts on both the bottom and
the top … so you can mount them “upside down” on the
tilt plate then mount the PTX in an inverted position on
truss or other structure if desired.
These pictures show the single thread on the TOP of the
Micro Studio Camera 4K …