Ruris AS200 FULL, Руководство пользователя

Страница: 35 / 40

EN
15
5.5 WELDING WIRE FEED
1. Install the coil with wire
2. Open the pressure arm of the mechanism and raise the upper roller on its pivot.
3. Position the feed roller according to the wire used (0.8 / 1mm).
4. Pull the wire detached from the coil and push it carefully through the wire guide behind
the mechanism. Push the wire over the groove of the feed roller and through the front
wire guide until it comes out of the gun connector about 100 mm.
5. Place the upper feed roller over the wire and close the pressure arm.
6. Cut any section of deformed wire and prepare the tip so that it is not sharp.
Note: You can use a file to remove the sharp tip of the wire.