Rupes BA 41 W, Инструкция по эксплуатации и техническому обслуживанию, Страница: 13 / 31

CONTENTS OF THE INSTRUCTION BOOK
- This booklet
- SAFETY INSTRUCTIONS
- List of authorised assistance centres
- Exploded view indicating spare parts supplied
PARTS OF THE TOOL
1 - Identification plate
2 - ON/OFF switch
3 - Speed control
4 - Spindle with screw thread for mounting disc pad
5 - Side handle
6 - 8 mm dia. rubber connector for connection to the water system
7 - Water flow regulator valve
8 - Abrasive disc pad
9 - Motor ventilation slots
SAFETY AND ACCIDENT PREVENTION INSTRUCTIONS
In addition to the standards reported in the “SAFETY
INSTRUCTIONS” booklet, the following requirements must also be
observed.
-
An isolation transformer must be inserted between the mains
and the tool
- Any operations carried out on the tool must be effected with the
power supply disconnected.
- Before starting the tool, ensure that it is held tightly and not in
contact with the work surface.
- The abrasive discs must be correctly fitted
ASSEMBLING THE TOOL
- Screw the side handle in the hole in the gearbox. The handle can
be mounted either on the left or right of the tool body
6
- Connect the tool to the water system via a hose of internal dia 8
mm inserted in the hose connector (6). Tighten using a hose clip.
The required water pressure is approximately 2 bar.
ASSEMBLING THE DISC PAD
- Screw the disc pad with abrasive disc onto the spindle
BEFORE STARTING THE TOOL
Ensure that:
- The body of the tool is dry; otherwise, dry it using compressed air
- There is an isolation transformer inserted between the mains
supply and the tool
- The power supply conforms with the characteristics of the tool.
- The power supply cable and plug are in perfect condition.
- The ON/OFF switch works properly though with the power supply
disconnected.
- The water feed device is connected and operational
- All the parts of the tool have been assembled in the proper
manner and that there is no evident damage.
- The ventilation slots are not obstructed.
STARTING-UP
STARTING AND STOPPING
- Starting: push the slide of the switch (2) forward; if the tool is to be
locked in the ON position, apply pressure to the front part of the
slide switch at the same time.
- Stopping: release the slide or, if locked in position, apply pressure
to the back part of the switch and allow it to return to the stop
position.