Runco Video Xtreme CineWide VX-3000d, Руководство по эксплуатации

Страница: 88 / 114

Maintenance and Troubleshooting
74 VX-3000 Installation/Operation Manual
PRE
L
IMINAR
Y
5.2
Troubleshooting Tips Table 5-1 provides some general guidelines for troubleshooting problems you may
encounter with the VX-3000. If the suggested solutions fail to resolve the problem or if you
encounter an issue not described here, please contact Runco Technical Support.
Table 5-1. Troubleshooting Chart
Symptom Possible Cause(s) Solution
The projector does not turn
on. • The VX-3000 is not
plugged in or the AC outlet
is not active.
• The main power switch (at
the rear of the projector) is
off.
• Lamp cover is not securely
attached.
• Ensure that the VX-3000 is
plugged in and that the AC
outlet is active.
• Turn on the power switch.
• Securely attach the lamp
cover.
The projector does not turn
back on after it was powered
off. • The projector will not turn
on for two minutes after
power-off, to protect the
lamp.
• Wait until the VX-3000
completes its cool-down
(POWER LED lights solid
orange).
The remote control does not
work correctly. • The batteries have run out. • Replace the batteries.
The projector is on and OSD
menus appear, but there is no
video image on-screen. • Incorrect source selection.
• Source component is not
turned on.
• Source component is
connected incorrectly or
not at all.
• Select the correct source.
• Turn on the source.
• Check cable connection
from source component to
projector.
A projected image from a
DVD is split or otherwise
scrambled. • DVD player is connected
to the Component input
and set to progressive
scan mode.
• Turn off progressive scan
on the DVD player.
Image is blurred. • The lens is not correctly
focused.
• Adjust the focus with the
remote control.
Image is too bright and/or
lacks definition in the bright
areas of the image. • Contrast is set too high. • Lower the contrast setting.
Image appears “washed out”
and/or dark areas appear too
bright. • Brightness is set too high. • Lower the brightness
setting.
Colors in the image are
swapped; for example, reds
appear blue or vice versa. • The Red/Pr, Green/Y or
Blue/Pb outputs from the
source are connected to
the wrong inputs on the
VX-3000.
• Ensure that the source
outputs are connected to
the correct VX-3000 input.
POWER LED lights solid red. • Internal failure. • Please contact your Runco
dealer for assistance.