Source Selection
is done by highlighting the desired source with the up or down arrows and
pressing ENTER. Sources may also be selected by pressing the left or right arrows on the front panel
of the Controller or the remote. Picture adjustments such as color, tint, brightness, etc, are unique per
source. To select a high-resolution source (input to the RGB/Component 15PIN input on the PFP
Controller), select either RGB HD or Component HD as appropriate. If you wish to use the DVI input
on the Projector, select DVI. The Controller will switch the Projector’s inputs accordingly.
Aspect Ratio
selection is done by highlighting 'Aspect Ratio' on the main menu and pressing enter.
The Aspect Ratio menu will then appear; and either ANAMORPHIC, LETTERBOX or 4:3 may be
selected. Aspect ratios may also be selected by pressing either the up or down arrow buttons, or by
one of the direct access buttons on the remote.
Installation
is used for adjustments usually made during the initial installation. This includes Lamp
Mode, Keystone and Picture Orientation.
Lamp Mode
allows you to select between ‘Normal’ (full light
output) and ‘Low’ (80% of full light output).
Keystone
allows the adjustment of trapezoidal distortion
caused by angling the Projector; picture for ceiling or floor, front or rear installations.
IR Code Set
allows the Controller to be set to one of four different IR Code Sets. This is useful if one of the Code
Sets has commands that are conflicting with other equipment, or other manufacturer’s IR Codes are
conflicting with the Controller.
Lamp Hours
may be checked in the Installation Menu as well.
24
