Runco PlasmaWall PL-50XA, Руководство по эксплуатации для владельца

Страница: 55 / 72

Operation
Runco PlasmaWall Owner’s Operating Manual 45
PRE
L
IMINAR
Y
Miscellaneous: Select Miscellaneous from the Service menu to set the following options:
• Language: Select Language from the Miscellaneous menu and press the up- or
down-arrows to select the OSD language. (Currently, only English is supported.)
• Menu Mode: This is the manner in which the OSD menus appear and disappear when
you press MENU. Choose one of the following:
0 = No transition; menus abruptly appear and disappear.
1 = Menus fade in and out.
2 = “Checkerboard” dissolve; menus appear and disappear in sections.
3 = “Window shade” effect; menus are drawn on a diagonal from top left to bottom
right, and retract in the opposite direction.
• Timeout - Short/Long: These settings control how long the OSD menus stay on
screen. Select a time-out period of from 2 to 60 seconds.
• Side Bar Color: This controls the color of the inactive image area. The range is from
-100 (black) to 100 (white).
The inactive image area is on either side of the active image area when using the
Standard 4:3 aspect ratio (or the entire screen when no incoming video signal is
present).
• Film Mode: Enable Film Mode to smooth out moving images from interlaced,
standard-definition (SD) sources. In most cases, the PlasmaWall detects the proper
“pull-down” rate and vertical frequency. However, if your source is jittery and/or tearing
you may wish to enable Film Mode to ensure stable processing for that source.
Resolution: The DHD Controller defaults to an output resolution of 720p. When using the
PlasmaWall with a computer or certain HD sources, you may want to force the DHD
Controller to use a different output resolution. If so, select Resolution from the Service
menu and choose one. Then, press
ENTER to confirm.
System Reset: To reset ALL DHD Controller settings (including image settings) back to
their factory defaults, choose System Reset from the Service menu.
A confirmation message appears, reminding you to save your settings before you perform
the reset, so that you can restore them afterwards. If you have done this, select Confirm to
continue with the reset. Otherwise, click Back to cancel.
Restore Saved Settings: Following a System Reset, select Restore Saved Settings to
apply all previously-saved settings to the PlasmaWall and DHD Controller.
This action is not undoable. Proceed with caution!
Before you
perform a System Reset, save ALL settings, including “Custom” ISF
Presets (page 40), ISF Day/Night presets (page 40), Output Shift
settings (page 42), Input Names (page 43) and Trigger settings
(page 44).
Caution