Runco DTV-940, Руководство по эксплуатации для владельца

Страница: 40 / 73

7-4
Change ProjectorAddress
Every projector requires an individual address between 0 and 255. This address
can be software installed.
To change that address, push the control disc up or down to highlight ‘Change Pro-
jector Address’ and press
ENTER. The Change Projector Address menu will be
displayed and the actual address will be filled in.
The first digit is highlighted. Select the individual digits by pushing the control
disc to the right or to the left. Reprogram with the digit keys on the RCU.
Press
ENTER to confirm.
Press EXIT to return the projector set up menu.
Change baudrate
The communication speed between projector and computer has 8 possible speeds.
The baud rate speed can be software set up. Highlight ‘Change Baudrate’by push-
ing the control disc up or down and press
ENTER to display the Baud rate menu.
The following baud rates are available :
- 9600
- 4800
- 2400
- 1200
- 600
- 300
- 150
- 110
The actual baud rate will be highlighted. To change the baud rate, push the control
disc up or down or to the left or to the right to select the desired baud rate and press
ENTER to accept this baud rate.
Power up mode
When pressing the power switch, the projector can start up in ‘operating mode’or
in ‘stand-by mode’.
Operating mode : the projector start up and displays image.
Stand-by mode : the projector start up in stand-by and waits until the stand-by but-
ton or a digit key is pressed.
To change the Power up mode, select Power Up mode by pushing the control disc
up or down and press
ENTER to toggle between ‘Operating’and ‘Standby’.