19
The Installation menu is where you can adjust the image orientation, adjust keystone and even check the
age of the lamp in the Projector.
When the Controller is turned on for the first time, the INSTALLATION item will not appear in the main
menu. To enable the INSTALLATION menu, there are two options:
· With the processor ON and no menus on-screen, simultaneously press the ENTER, UP and LEFT
buttons (you don't need to hold them down). Release the three buttons and press MENU, ensure
INSTALLER ADJUST is now on the bottom of the main menu.
· With the remote control, press button 6 (with no menus on-screen). After pressing '6', press MENU and
ensure INSTALLER ADJUST is now on the bottom of the main menu.
After INSTALLER MODE has been accessed, press MENU, highlight INSTALLER ADJUST and press
ENTER. This will bring up the INSTALLATION MENU, shown here:
Installation Menu
INSTALLATION
Lens Focus
Lens Zoom
Lens Shift
Keystone
Picture orientation
Lamp hours
001
Once the installation mode has been enabled, you will also be
able to access Luma Enhance, Chroma Enhance and Color
Balance (see pg. 18). These items will not appear anywhere in the
menu until the installation mode is enabled.
Lens Focus
This optically focuses the lens. This lens is controlled via the Lens Focus function electronically.
However, if the image is too blurry to see, you can rotate the lens manually until the image is sharper.
Lens Zoom
This “zooms” the lens, which optically makes the image larger or smaller. During initial installation, use
this to properly size the image to fit the screen.
Lens Shift
This function allows you to shift the lens up and down. Please refer to page 8 for details on the
vertical offset parameters.
