Make sure the SFP module is inserted into the slot in the correct direction until it hits the internal stop and is locked in
place.
Figure 3-2
4)
Verify the SFP module is locked in place with the thumb.
5)
Pull the SFP module out without rotating the handle outwards. If the SFP module cannot be removed, it is locked in
place. If the SFP module is removed, insert it again and push it to the internal stop.
Do not remove the rubber cap from SFP module before connecting fibers.
Do not insert the SFP module with a fiber into a slot. Unplug the fiber before installing the module.
3.10 Replacing Swappable Modules (Optional)
Replace a swappable module in any of the following circumstances:
The module is faulty.
The module must be replaced based on networking requirements.
Make sure the optical modules connected to both ends of a fiber are the same type while replacing swappable
optical modules.
Replacing SFP Module
Take the following steps to replace SFP modules are as follows:
1)
Wear an anti-static wrist trap close to your skin and have it properly grounded.
2)
Pull out optical fibers from SFP module.
3)
Push down the handle of the module you want to remove and keep it horizontal.
4)
Hold the handle and slowly pull out the module.
5)
Insert a rubber cap into the module and place the module in a packing bag.
Do not stare into the fiber during the operation to avoid eye injury.
Do not touch the edge connector while removing SFP module.