4-7
Ruijie RG-MTFI Implementation Cookbook (V1.0)
Quick Start
The following figure shows the power cable of RG-MTFi-M520 with two types of vehicle-mounted
connector terminals. Select a connector terminal according to actual requirements, remove the stopple of
the terminal, and properly connect the terminal to a matched terminal in the vehicle (VCC/yellow, ACC/red,
and GND/black should be correspondingly connected). Do not remove the stopple of the other unused
terminals to prevent exposing metal wires.
Figure 4-4 Power Cable of RG-MTFi-M520
Caution:
1.
Make sure that output of the power supply and power fall within an available range before the
connection, and use the multimeter to check whether the vehicle power supply is 12 V or 24 V and whether the
vehicle power cable is properly connected.
2.
Adopt the solid state connection mode for the power cable adapter to avoid tension.
3.
Conduct cabling management in hidden positions in a neat and artistic way, and apply protective cover
over the cables.
4.
Improper connection of the ACC may lead to a risk of losing system files.
Adapter (Available for tests only)
Select an adapter with a voltage within the required range. Specific requirements are as follows:
Input voltage: 100
–
240 V AC; input current
: ≥ 1 A
Output voltage: 9
–
36 V DC; output current
: ≥ 2 A
4.1.4 Power-On and Begin to Use
Power supply and antenna verification
Check whether the power cable on the rear panel is properly connected.
Check whether the antennas are properly connected.
Power-off
