
Ruideng Technology Co. Ltd.
- 4 -
button to display *.**A
、
**.*P
、
**.*V followed by recycling.
3. Open or close load output
Press “ON/OFF” button, you can open or close load output
4, Set load default boot status (open or close status, Factory default close status
)
Press and hold “ON/OFF” button to set load default boot status freely. Press and hold
“ON/OFF” button, if the LED will display “--ON”, as picture 4, the load will open output when
power on next time; If the LED display”-OFF”, as picture 5 show,
the LED will display current value flashing at last shutdown
when power on next time, then press “ON/OFF” button to open
output.
5, Set the load output recovery
mode after protection
removed
.
Press and hold “SET” button to set output recovery
mode after
protection
removed.
Press and hold “SET” button
, if the LED will
display “--ON”, as picture 4, and the protection was removed,
the load will recover to work; If the LED display”-OFF”, as picture 5 show, and the protection
was removed, the LED still show protection status, then press “ON/OFF ‘button, the display
will display present setting current flashing, then press “ON/OFF‘ button again, the load
recover to work.
NOTE:
Please check the output current of power bank carefully. The current of the general
power bank is generally small, so adjust smaller current when the load was used.
Application
Assist to measure
Micro USB cable good or not
Assist to measure
Type
-
C cable good or not
Assist to measure output current capacity of charger good or not
The usage of large batch ageing test at the charger factory