User
’
s Manual of RDC6442G(U)-DFM-RD Control System
SHENZHEN RUIDA TECHNOLOGY
51
percentage is, the more the laser power reduces. The laser power to set should be
larger in order to reach the same scanning depth. The purpose to select the special
mode is to make the laser light at high power and short time. On the depth scanning the
effect that the bottom is flatter is obtained, but it should be noticeable that if the speckle
adjustment is not appropriate, it can achieve this goal. If the high power remains short,
the lighting mode will influence the life of the laser. The system will default the selection
of general mode.
Speckle Size
: When the general mode is selected as the scanning mode, this
parameter will become ineffective; when the special mode is selected, this parameter
will become effective. The controller will control this parameter among 50%~99%.
The cutting and scanning parameters can’t exceed the limited ones
in the axle parameters. If so, the setting will become ineffective and
the system will automatically cover the parameters with the axle
parameters.
（
3
）
Feeding parameters
Before-feeding Time Lag
: settable at 0~300s. The lagged time can facilitate
user’s feeding and picking on the feeding device.
After-feeding Time Lag
: settable at 0~9.9s. It can facilitate the feeding
device’s delaying in jarring after moving to the correct position and waiting for the 2
nd
work after the feeding axle stands still completely.
Progressive feeding
: If this item is enabled, then the dummy array graph on Y
direction will run in the same position, running one line graph, the U axes moving one
time to feed, the moving length of U axes is the interval of the two lines graph on Y
direction.
Progressive feeding repay
: Because of the imprecision of U axes’ moving,
there can set a value to repay the interval of the two lines graph on Y direction.
（
4
）
Reset parameters
Reset Speed
: it means the speed of X/Y-axle linkage reset to the origin.
X axle start-up reset(Auto home)
Y axle start-up reset(Auto home)
Z axle start-up reset(Auto home)
U axle start-up reset(Auto home)
You can select “Yes” or “No” in the field of the above four parameters, which is used to
confirm whether each axle can be reset on the startup.
（
4
）
Go scale parameters
Go scale Mode
: “Blanked Bordering” means idling to start border preview;
“Outputted Border Cutting” can manually cut off the well-processed figure; “4-corner
Dotting” means to emit the light at four corner points of the frame to make a point and
turn off light. The size and position of this figure can be checked intuitively through the
four points. The bordering speed is the speed value set on the keyboard when the
system is idle. For light output, its minimum/maximum power is the corresponding value
Prompt
