Ruida Technology RDC6445G, Руководство пользователя

Страница: 44 / 72

RDC6445G/S Control System manual
SHENZHEN RUIDA TECHNOLOGY 37
At this point, the user can press the "up/down" key to select a parameter, press the number key
to modify the numerical parameters (such as "Idle speed"), for non-numerical parameters (such as
"Scan mode"), when the "blue selection block" stops on the parameter, press the
<Enter> key to
enter the modification mode (the "blue selection block" right side becomes ), press the
"up/down" key. Modify the parameters. After the modification, press the <Enter> key to exit the
modification mode. When the current page parameters have been modified, move the "blue
selection block" to the "Write" entry and press the
<Enter> key. The panel saves all the parameters
on the motherboard and takes effect, and displays the save progress on the "Write" entry. If the user
wants to verify that the parameters are saved successfully, he can move the "blue selection block" to
the "Read" entry and press the
<Enter> key, then the panel reads the motherboard parameters again
and displays them. When pressing the "left/right" key, the Blue Select Block switches back to the
parameter category, as shown in Figure 8.5.1-1, where the user can select another parameter
category to modify or press
<Esc> to return to the menu interface.
Other interface operations are similar, and the interface is displayed as follows:
Figure
8.5.1-3
Figure
8.5.1-4
Figure
8.5.1-2