Ruckus Wireless T811-CM, Руководство по установке

Страница: 25 / 54

T811-CM AP Installation Guide, 800-71436-001 Rev A
25
Installing the T811-CM
Deploying the T811-CM
Installing the Cable Power Tap
The CATV coaxial cable used in the field deployment must have 60 to 90 VAC power multiplexed
with the RF signal on the coaxial cable, since the T811-CM Connector B is used for both electrical
power and the RF signal.
Ruckus Wireless recommends installing a cable power tap (Antronix MGT2000-SDPE tap, or
equivalent) close to the T811-CM. Refer to the manufacturer’s instructions to mount the cable power
tap on the coaxial cable.
Figure 7 shows a typical cable power tap and connection to the CM
using an RG6 quad shield cable. Table 4 describes the elements in Figure 7 .
NOTE
If the F connector on the T811-CM is damaged, then refer to Appendix C: Replacing the F
Connector Adapter .
1
Use a customer-supplied cable, connect any port on the cable power tap to the F connector on
the T811-CM.
2 Using a wrench, tighten the cable F connectors to 3.4N.m or 30in-lbs.
Figure 7. Cable Power Tap Connection to the T811-CM Cable Modem
Table 4. Typical cable power tap connections
No. Description
1 • Line amplifier/high output node.
2 • Typical cable power tap.
Note:
Use any connector on the power tap.
3 • Cable modem.
Continue with Powering the T811-CM with POC .
2
1
3
2