Ruckus ICX 7850 Switch Hardware Installation Guide
27
Part Number: 53-1005580-01
Mounting the Device
Installing the 1U, 1.5U, and 2U Universal Kit for Four-Post Racks (XBR-R000295)
Attaching the Extension Brackets to the Device
Complete the following steps to attach the extension brackets to the device. There are medium and long extension brackets that you can
use for this step. Choose the correct extension bracket for the depth of your rack.
1.
Position the right extension bracket along the side of the device as shown in
.
2.
Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the extension bracket and then into the holes
on the side of the device. Use the upper and lower screw holes, leaving the center holes empty.
3.
Repeat Step 1 and Step 2 to attach the left extension bracket to the left side of the device.
4.
Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
FIGURE 17
Attaching the Extension Brackets to the Device
Installing the Device in the Rack
Complete the following steps to install the device in the rack.
1.
Position the device in the rack, as shown in
, providing temporary support under the device until the rail kit is secured to
the rack.
2.
Attach the right front bracket to the right front rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use
the upper and lower holes in the bracket.
3.
Attach the left front bracket to the left front rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the
upper and lower holes in the bracket.
4.
Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
1
Bracket extensions
2
Screws, 8-32 x 5/16-in., flathead Phillips
