Ruckus Wireless Fiber Node, Быстрая настройка, Страница: 3 / 4

Copyright © 2013 Ruckus Wireless, Inc.
Page 3 of 4
Published November 2013, Part Number 800-70378-001 Rev C
S
TEP
5: I
NSTALLING THE
F
IBER
N
ODE AND
/
OR
A
CCESS
P
OINT
A. If you are mounting a Fiber Node, then continue with
Step B. If you are mounting an AP, then continue with
Step D.
B. Slide the FN enclosure and device mounting bracket
assembly onto the dual-slide adapter plate, clean oil
and grease off the screw threads, apply Loctite to the
screw threads, and tighten the two captive screws (A)
to 3.38 N.m (30 in-lbs).
C. If required, repeat Step 5: Installing the Fiber Node
and/or Access Point . When you have mounted the
last of the APs and FNs, continue with Step 6:
Installing the Fiber Optic Cable .
D. Slide the AP enclosure and device mounting bracket
assembly onto the dual-slide adapter plate, clean oil
and grease off the screw threads, apply Loctite to the
screw threads, and tighten the two captive screws
(with captive springs) to 3.38 N.m (30 in-lbs).
E. If required, then repeat Step 5: Installing the Fiber
Node and/or Access Point . When you have mounted
the last of the APs and FNs, continue with Step 6:
Installing the Fiber Optic Cable .
S
TEP
6: I
NSTALLING THE
F
IBER
O
PTIC
C
ABLE
A. Open the fiber enclosure by loosening the four
captive fasteners on the enclosure lid.
B. Insert the fiber optic cable through the cable gland
and prepare the fiber cable with the supplied shield
bond connector. Install the shield bond connector per
the manufacturer’s instructions (Scotchlok 4460-D\FO
Shield Bond Connector).
C. Attach the ground wire to the shield bond connector
and then secure the connector to the fiber enclosure
with wire ties.
D. Wind “out of service” fibers around the left fiber
spool. Secure fibers to the enclosure with wire tie.
E. Wind the “in service” fiber around the right fiber
spool and the insert fiber connector into mating
sleeve.
F. Ensure the weather seal gasket on the enclosure lid is
not damaged or out of position. Close lid and torque
the four captive screws to 3.38 N.m (30 in-lbs).
S
TEP
7: I
NSTALLING THE
M
EDIA
C
ONVERTER
A. Open the fiber enclosure by loosening the four
captive fasteners on the enclosure lid.
B. Make sure that the PoE Splitter is set to 12V (A).
C. Place the media converter unit into the fiber
enclosure. Secure the unit to the enclosure by
torquing the six M3 captive screws to 0.8 N.m
(7 in-lbs).
A
(with M25 gland)
(with FOTC)
A