Ruby 48bh 3SD, Использование и обслуживание

Страница: 23 / 27

16
Brush/es cleaning
Disassemble the brush and clean it with a water jet (for the
disassembly see under “BRUSH/ES DISASSEMBLY”).
Squeegee cleaning
Keeping the squeegee clean guarantees always the best
drying action.
For the cleaning it is necessary to:
1.
Take off the squeegee hose (3) from its coupling.
2. Disassemble the squeegee from its support by rotating
the lever (2) counterclockwise and making slide the
stud bolts (1) in their slots up to their release.
3. Clean with care the internal part of the squeegee inlet
eliminating eventual dirt residuals.
4. Clean with care the squeegee rubbers.
5. Reassemble all parts.
WEEKLY MAINTENANCE
Rear squeegee rubber replacement
Check the squeegee rubber wear and eventually turn or
replace it.
For the replacement it is necessary to:
1.
Lift the squeegee acting upon the lever.
2. Uncouple the hook (1) of the rubber holder blade,
release the extremities (2) from the squeegee body and
take off the rubber (4).
3. Turn the rubber (4) to a new side or replace it.
To reassemble the squeegee repeat reverse the operations
above-mentioned, inserting the rubber (4) on the guides
(3), couple the extremities (2) of the rubber holder blade
onto the squeegee body and finally block the hook (1).
Squeegee hose cleaning
Weekly or in case of insufficient suction, it is necessary to
check that the squeegee hose is not obstructed. Eventually,
to clean it, proceed as follows:
1.
Take off the hose from the squeegee coupling (1) and
release the guide spring of the suction hose (2).
2. Wash the inside of the hose with a water jet, from the
squeegee hose side.
3. To reassemble the hose repeat reverse the operations
above-mentioned.
Cleaning of water tank and filter