VC-400LT/RT+ VDSL2 CO&CPE Router MANUAL Ver.B3
6
Chapter 1. Complete Installation
1.1 Hardware Installation
This chapter describes how to install the VC-400LT/R and establishes network
connections. This may install the VC-400LT/R on any level surface (e.g., a table or
shelf). However, please take note of the following minimum site requirements before
you begin.
1.2 Pre-installation Requirements
Before the start actual hardware installation, make sure to provide the right operating
environment, including power requirements, sufficient physical space and proximity to
other network devices that are to be connected. Verify the following installation
requirement:
Power requirements: DC12V/1A or above.
The VC-400LT/R should be located in a cool dry place, with at least 10cm(4in)
of space at the front and back for well ventilation.
Place the VC-400LT/R away from direct sunlight, heat sources, or areas with
a high amount of electromagnetic interference.
Check if network cables and connectors needed for installation are available
Do Not install phone lines strapped together with AC power lines, or
telephone office line with voice signal.
Avoid installing this device with radio amplifying station nearby or transformer
station nearby.
Please note VC-400RT+ internal splitter, can pass through voice spectrum is
0KHz ~ 120KHz.
1.3 General Rules
Before making any connections to the VC-400LT/R, note the following rules:
Ethernet Port (RJ-45)
All network connections to the Router Ethernet port must be made using Category
5 UTP for 100Mbps;
Category 3, 4 UTP for 10Mbps
No more than 100 meters of cabling may be use between the MUX or HUB and an
end node.
Phone Port (RJ-11)
All Phone set connections to the RJ-11 Port must use 24~26 Gauge phone wiring.
We do not recommend using 28 gauge or above phone line.