
- EN 4 -
Cancelling / Disabling the alarm function:
•
In standby mode, press Alarm set [5] for 3 seconds unit Alarm 1 flashes. Press [5] to confirm Alarm 1
is selected.
•
Press [10/11] once more until the
radio or bell icons disappear.
•
Press [5] to confirm and cancel alarm set 1. The “Alarm 1” icon will not flash and the function has
been cancelled.
•
To cancel “Alarm 2”, repeat the steps above.
•
If no key is pressed for 20 seconds, the system will go back to normal mode.
•
Output format as below:
Output
LCD display
Beeping sound
Display shows bell symbol
Radio
Display shows radio symbol
Cancel / Disabled
The bell , radio
and alarm symbols are gone
4. Using the snooze function
When the alarm is ringing, press [7] “SNOOZE”. The display will flash “SNOOZE”. The alarm will stop,
but ring again every 9 minutes. Press [2] to completely turn off the alarm.
5. Listening to FM radio
•
For radio mode, press [2]. The display will show FM and the current frequency in digits, e.g.
FM92.6 MHz.
•
When the radio is on, you press can adjust the signal by pressing [4/5] to search for the next station.
5.1 Storing a station to memory – as a preset station
•
While already in radio mode, press [4/5] /– to select the channel. Press SCAN/ MEM [9] to
start the memory. The display will show MEMORY and flash the station number (e.g. P01 up to P20).
Press /– [10/11] to select the desired program station number, e.g. P01, P02 Up to P20.
Finally, press MEM [9] to confirm and save this station to the preset stations.
5.2 Returning to a preset station
•
When radio mode is on, press /– [10/11] to select the desired preset station number, P01,
P02, up to P20. The display will then show MEMORY, the preset station number (P01 or whichever
preset station number is chosen) and the FM frequency.
•
Once the preset station has been selected and confirmed or you have waited for 3 seconds, the
display will show the current time and FM frequency.
5.3 SCANNING
•
With radio mode on, press [9] to activate SCAN mode.
•
The radio will automatically scan the frequency and save the preset station to memory, with a total of
up to 20 different radio stations. Once SCAN finishes scanning and stops automatically, it will return
to preset station no. P01. The display will show the current time and FM frequency.
When the SCAN function is activated, the newly found stations will replace the preset stations
that have been previously stored in the memory.
Содержание RR80
Страница 57: ...BBI_RR80_1601_Ver2 2...