Rubicon netgate SG-1100, Руководство пользователя, Страница: 5 / 58

Security Gateway Manual SG-1100
Warning: The default IP Address on the LAN subnet on the Netgate firewall is
192.168.1.1/24
. The same
subnet cannot be used on both WAN and LAN, so if the default IP address on the ISP-supplied modem is also
192.168.1.1/24
, disconnect the WAN interface until the LAN interface on the firewall has been renumbered
to a different subnet (like 192.168.2.1/24 ) to avoid an IP Address conflict.
To change an interface IP address, choose option 2 from the Console Menu and walk through the steps to change
it, or from the WebGUI, go through the Setup Wizard (opens at first boot, also found at
System -> Setup Wizard
)
and change the IP address on Step 5. Complete the Wizard and save the changes.
1.2 Initial Configuration
Plug the power cable into the power port (shown in the Input and Output Ports section) to turn on the Netgate®
Firewall. Allow 4 or 5 minutes to boot up completely.
Warning: If your DSL or Cable Modem has a default IP Address of 192.168.1.1, please disconnect the Ethernet
cable from the WAN port on your SG-1100 Netgate Security Gateway before proceeding. You will need to change
the default IP Address of the device during a later step in the configuration.
1. From the computer, log into the Web Interface
Open a web browser (Google Chrome in this example) and type in
192.168.1.1
on the address bar. Press
Enter
.
Fig. 1: Enter the Default LAN IP Address
2. A warning message may appear. If this message or similar message is encountered, it is safe to proceed. Click
the
Advanced
Button and the click
Proceed to 192.168.1.1 (unsafe)
to continue.
3. At the Sign In page, enter the default pfSense
®
Plus username and password and click
Next
.
• Default Username:
admin
• Default Password:
pfsense
1.2.1 The Setup Wizard
The following steps will step through the Setup Wizard for the initial configuration of the firewall.
Note: Ignore the warning to reset the ‘admin’ account password. One of the steps in the Setup Wizard is to change
the default password.
1. Click Next to start the Setup Wizard.
2. Click
Next
after you have read the information on Netgate Global Support.
© Copyright 2021 Rubicon Communications LLC 3