4. Install Repeaters in series
1.
Register one repeater to your base station as described above
2.
Install “Setup_wrs4002cfg” on your laptop.
3.
Apply 120 V or 230Vac to the power supply and connect the serial bus to the Com port to the registered repeater.
Note that power must be switch on before connecting the serial bus to the Com port. Fig.1
Fig.1
Fig.2
4.
Unit is ready for communicate with the laptop. Fig.2
5.
Start the program Wrs4002cfg. An empty scheme of the program Rtx4002 Repeater config program will appear. Fig.3
Fig.3
Fig. 1a
6.
In the COM port drop down box select the COM port where the single wire bus is connected. Fig.4
Fig.4
7.
Click on the “Load” button in the “REPEATER” window. Fig.5
Note:
The kit either comes with a cable for serial
connection or a cable for USB connection.
Fig.1a: Shows the USB connection cable
Fig.1: Shows the serial connection cable, inside the
dashed red circle.
If delivered with the USB cable, it replaces the serial
cable highlighted by the red dashed circle
.
The USB cable
is also shown as a COM port in Windows.
