RTS TBX - TriBus ADAM, Инструкция пользователя

Страница: 22 / 48

18
Configuration
To configure the TBX-Tribus card , the following steps must be completed for the Intercom System to be active:
Step 1 Configure each MCII-e Master Controller IP Address for the Ethernet (page 18)
Step 2 Configure the size of your Intercom system for each frame (page 19)
NOTE: Each frame must be configured exactly the same. The number of ports must not exceed the number
of ports allowed for the number of frames in the intercom system.
Step 3 Configure the frame using the Frame Mapping window in AZedit (page 23)
Configure each MCII-e Master Controller IP Address for the Ethernet
To configure the IP Address for the MCII-e , do the following:
1.
Verify you are serially connected to AZedit .
You must be connected serially to make any changes to the Ethernet Setup window in AZedit .
2.
Open AZedit .
3.
From the Options menu, select Ethernet Setup .
The Ethernet Setup window appears .
4.
In the IP Address field, enter the IP Address for the MCII-e.
5.
In the Network Mask field, enter the Network Mask for the MCII-e, if applicable
6.
In the Default Gateway field, enter the Default Gateway for the MCII-e, if applicable.
NOTE: If you are unsure of your IP Address, Network Mask, or Gateway Address, contact your System
Administrator for this information.
7.
Click Apply .
The IP Address is set for the MCII-e .
8.
Repeat steps 1-8 for each frame in your system.