RTS OMNEO OEI-2, Руководство пользователя, Страница: 33 / 40

OEI-2 Configuration 33
Bosch Security Systems, Inc. Technical Manual F.01U.287.527 Rev. 01
Mode 2 - Set GPIO Mode
NOTE: The Set GPIO Mode can only be configured using IPedit or from the front panel.
Set GPIO Mode allows the user to select between two (2) modes:
1 Keypanel Mode (single-port mode) – All GPI/Os are controlled by one (1) port. Associating the GPI/O with one port
allows you to access/address the GPI/O in UPL Statements. Mode 3 is used to
define the port to used. The GPI/O is associated with J1. This means that Port 0
has eight GPI/O’s mapped to it. Connected to J1 is a keypanel with the keypanel
ID of 33 in AZedit.
To use the GPI/O, you can create UPL statements. But be careful to assign the
correct Output Action parameters:
RLY1 and OPT1 are Local GPIO 9 on the same keypanel
RLY2 and OPT2 are Local GPIO 10 on the same keypanel
All Keypanel Mode (multi-port mode) – Each port is associated with its corresponding GPI/O. This means if keypanel 1
is connected to GPI/O 1, it is associated with the corresponding GPI/O port.
GPIO1 and RLY1 are paired and assigned to the same panel. These cannot be
split across devices.
When using this mode, an additional GPI/O is available on each port.
RLY1 and OPT1 are represented in AZedit by Local GPIO 9 on the keypanel
connected to J1
RLY2 and OPT2 are represented in AZedit by Local GPIO 9 on the keypanel
connected to J2
FIGURE 14.
Single Keypanel – Channel 1 (LED 2 is solid)
FIGURE 15.
Single Keypanel – Channel 2 (LED 3 is solid)