RTS BTR-30N, Руководство по эксплуатации

Страница: 38 / 90

36 Operation BTR-30N, TR-30N, TR-32N
To enable or disable the antenna power , do the following:
1.
From the status screen, press MENU .
2.
Using the UP/DOWN arrow buttons, select Base Main .
3.
Press SET .
4.
Using the UP/DOWN arrow buttons, select MORE... .
5.
Press the DOWN arrow button .

The stage announce level starts flashing.
6.
Press SET until Antenna Power flashes.
7.
Using the UP/DOWN arrows, adjust the setting .
8.
When finished, press SET .
9.
Step through the other settings in the screen by pressing
SET .

After the last option on the screen, the base main selection
menu appears.
10.
Press MENU twice to go back to the status screen.
NOTE: The base defaults back to the status screen if no
action is taken after five (5) minutes.
CAN Bus Number
The CAN Bus Number for a base station must be set only in
multiple base station configuration and only if the operator
wishes to have the following features shared among multiple
base stations:
•
First-On-Latch – Out of receiver channels (Push to transmit)
•
Automatic beltpack TX power control
•
Automatic beltpack user ID assignment
•
Beltpack TX and Talk shutdown via the base front panel
FIGURE 48.
Base Number
Table 1 lists valid base number settings. Please see “Connection
of Multiple Base Stations with the Link Cables” on page 40.
To set the CAN bus number , do the following:
1.
From the status screen press MENU .
2.
Using the UP/DOWN arrow buttons select More...
3.
Press the DOWN arrow button .
4.
Press SET until the Base Number option flashes.
5.
Using the UP/DOWN arrow buttons, set the number .
6.
When finished, press SET .
7.
Step through the other settings in the screen by pressing
SET .

After the last option on the screen, the base main selection
menu appears.
8.
Press MENU twice to go back to the status screen.
NOTE: The base defaults back to the status screen if no
action is taken after five (5) minutes.
Intercom Settings
There are multiple parameters to set in the Intercom Setting
menu:
•
2-wire intercom type: Telex, RTS, Clear-Com, Off
•
Only intercom 1 active, only intercom 2 active, both
•
2-wire intercom input/output levels
•
4-wire intercom on/off
•
4-wire intercom input/output levels
TABLE 1.
Valid Base Number Settings
Base Number Function
01 Master
02 Servant
03 Servant
04 Servant
05 Servant
06 Servant
07 Servant
08 Servant
09 Unassigned (Default)