RTS BTR-30N, Руководство по эксплуатации

Страница: 50 / 90

FIGURE 66.
Multiple base stations connected via 2-wire audio cable
and WTA plus CAN through via BLCs
48 Operation BTR-30N, TR-30N, TR-32N
Setup
1.
Connect the power cords to the base stations.
IMPORTANT: Do not power up the base stations.
2.
Connect the transmit and receive antennas to the base
stations.
NOTE: The color dots on the rear of the base should match
the color rings of the antennas.
3.
Connect the main intercom audio channel(s) to the base
stations.
NOTE: This may be 2-wire intercom. This could also be 4-
wire intercom via a matrix type wired system.
4.
Connect the Base Link Cable between base stations.
NOTE: Verify the OUT of the first base station connects to
the IN of second base station and follow the same
connection pattern forward.
5.
Place CAN bus termination plugs (CAN-T) at the
beginning and end of the networked base stations.
6.
Power-up all base stations .
7.
Set all base stations to factory defaults via a four-button
reset; MENU + SET + UP + DOWN .
8.
Power-down all the base stations.
9.
Power-up the first servant base station .
10.
Set the servant base station to all unique receive
frequencies.

The transmitters switch off automatically when the master
base station takes control of them.
NOTE: Leave the base number at the default of 09.
11.
Setup via the BTR-30N software menus the intercom, local
headset, auxiliary, stage announce, etc. as detailed in
BTR-30N Operation.
NOTE: Leave the base station powered-up.
12.
Power-up the master base station .
13.
Set the master base station to all unique transmit
frequencies.
14.
Setup via the BTR-30N software menus the intercoms,
local headset, auxiliary, stage announce, etc. , as detailed
in BTR-30N Operation.
15.
Set the master base station with its transmitters on to
master base number 01.