RTS BTR-30N, Руководство по эксплуатации

Страница: 16 / 90

18 Introduction BTR-30N, TR-30N, TR-32N
TR-32N – Top Panel
FIGURE 7.
TR-32N Top Panel
1.
On/Off and Volume Control - Turns beltpack power on
and controls headset volume for intercom channels “1” and
“2”. Either knob, “1” or “2”, turns the beltpack on. Both
knobs must be off to turn the beltpack off. If only one knob
is on, the intercom channel “1” or “2” is on for both
transmit and receive.
2.
Wireless Talk-Around (WTA) - When pressed, the user’s
audio disconnects from the wired intercom, auxiliary input/
output, and the base station’s local headset. Other beltpack
users on that audio channel can hear the user as normal. The
software can select which intercom channel(s)—1, 2, 1+2,
or the currently selected channel—is activated with the
WTA button. The WTA button activates the nearby red
LED as well as the software-selected intercom channels
TALK LED if not already active.
3.
Stage Announce (SA) - When pressed, the user’s audio
routes to the stage announce connector on the back of the
base station. The user also loses their sidetone, indicating
stage announce is active. The other wireless beltpacks and
wired users do not hear the user’s audio. The button is non-
latching and activates the nearby red LED and TALK
button.
4.
Talk Button - Press to enable the audio path to intercom
channels 1, 2, or 1+2, from the local headset microphone.
The associated TALK LED #6 turns red when enabled. A
quick press and release latches the talk function, unless
latching has been disabled., Holding the button for over 1/2
second causes the audio path to be enabled only for as long
as the button is held. If the talk function is latched on,
pressing the talk button again and it turns off.
5.
Low Battery/Peak (BAT/PK) Light - Light flashes once
when unit is turned on if the battery is good. If the light
stays on, the battery is low. If the light does not flash, the
battery is dead. A normal microphone gain setting causes
the LED to flash for some words at normal speech levels. If
the gain is too high, the LED displays red during all words
at normal speech levels.
6.
Talk Light - Turns red when enabled by associated TALK
or WTA button.