RTRMAX RTM711, Руководство пользователя

Страница: 7 / 17

OPERATION
Turn on the water supply tap fully.
Release the safety lock FIG.7 and FIG. 8, then press the trigger for a few seconds to allow air to escape and to
discharge residual pressure in the hose.
Keeping the trigger pressed, push the switch to start the motor FIG.9.
When re-starting the motor, always keep the trigger pressed.
NOTE:
THE MOTOR ONLY RUNS WHEN THE TRIGGER IS OPERATED.
Fill the detergent tank to the level indicated through the inlet FIG. 10.
CORRECT USE OF STANDARD ACCESSORIES
The washer is equipped with the adjustable nozzle.
Jet adjustment from pencil to fan FIG. 11.
WARNING: DO NOT ADJUST THE NOZZLE WHILE THE TRIGGER IS SQUEEZED.
CORRECT USE OF TURBO NOZZLE
For increasing washing power, use the turbo nozzle kit as follows:
Turn off the high pressure washer. Unscrew the adjustable head and fit the turbo nozzle onto the lance. Turn the
high pressure washer back on.
RECOMMENDED CLEANING PROCEDURE
Dissolve dirt by applying detergent with the fan jet to the dry surface. On vertical surfaces, work from the
bottom upwards. Leave the detergent to act for 1 to 2 minutes, but do not allow to dry out. Apply the high from
the surface, working from the bottom upwards.
Avoid allowing the rinsing water to run on to unwanted surfaces.
STORAGE (FIG.12 – FIG. 15)
Switch off the washer.
Turn off the water supply tap.
After use, the detergent residuals should be removed from the tank.
Discharge residual pressure by pressing the trigger until no more water comes out of the lance nozzle.
Engage the gun safety lock.
Remove the plug from the socket.
Operate the washer with non-corrosive/ non-toxic antifreeze before storing for the winter.
WARNING:BEFORE REUSING, COMPLETELY FLUSH THE UNIT OUT WITH PLAIN
Fig.14 Fig.15
Fig.16