RTRMAX RTH113, Инструкция по эксплуатации

Страница: 5 / 19

Проверил: Р.Ч./24.03.2015г
CONTINUOUS OPERATION
Push the variable speed switch trigger and at the same time push the continuous operation
lock .
The stop continuous operating, push variable speed switch and then release.
SPEED ADJUSTING WITHOUT STEP
The tool speed can be changed by pressing on/off switch. If the on/off switch trigger is pushed
slightly , it provides low speed . So the tool can be controlled easily. Do not force the tool as far
as stop it.
ROTATING SPEED SELECTION
Required rotating speed can be adjusted by selecting.
Required rotating speed depends on material and it can be determined best by trying .
After working low rotating speed for cooling the tool , run the tool no-load about 3 minute.
CHANGING ROTATING DIRECTION
Change the rotating direction when only tool is stopped.
The tool’s rotating direction can be
changed by Forward/reverse button (Forward/reverse buton is locked when the switch is on).
Right direction
Push the forward/reverse button end of the left way ( for loosing or dismounting screws and
sockets).
Left direction
Push the forward/reverse button end of the right way ( for loosing or dismounting screws and
sockets).
MAINTENANCE AND CLEANING
Before any work on the machine itself, pull the mains plug.