Charging procedure
Only charge the battery set when the ambient temperature is within 10° - 40° C.
procedure will proceed.
The battery set is completely loaded and ready for use once the green LED is lit and the red
LED is OFF – after approximately one hour.
Defective or used battery sets must be disposed of in specialised refuse, and
must not be placed in domestic refuse.
Keyless drill chuck
The keyless drill chuck (1) allows the clamping of drill bits or other tools without the use of a drill
chuck key.
its central position.
Rotate the front section of the drill chuck (1) to the right to open the jaws until the tool can be
inserted.
Insert the drill bit or the tool as far as it will go into the drill chuck.
Ensure that the drill bit or tool is seated correctly and centrally as you close the drill chuck.
Left / right motion direction
The rotation direction of the drill chuck (1) can be changed using the rotation direction switch
Before their first use, the battery set (5) must be loaded.
Only use the provided adaptor to charge the battery set.
Plug the adaptor to a 230V alternating voltage source.
The battery set (5) should under no circumstances be disassembled.
To remove the battery set, press the attachment clip (6) on the top side of the battery set
and extract the battery set (5).
Connect the plug of the charger to the loading-socket of the battery-set.
Red LED will light once the battery has been connected to the charger and the charging
Before inserting a drill bit or other tool, the rotation direction switch (3) must be switched to
To close the drill chuck, rotate the front section to the left to close the jaws.
(3).
