6
Installation
Installation should be performed by qualified personnel only.
Take care to position the antennas in a location with strong signals.
Install in a location that is free of water and dust.
Locate the 10-position harness and insert into the corresponding connector of the
RTITraq, then connect the wires into the vehicle circuits as shown below:
Wiring diagram
1. Note: The orange wire can be connected to the original car horn; it can also be
connected to a separate siren (purchased separately).
2. Determine whether the door switch is positive- or negative-active. If positive, then
connect the green wire; if negative, then connect the blue wire.
3. Install the Reset button and SOS button within a driver's convenient reach.
4. Insert the shock sensor plug into the sensor jack. (shock sensor is optional)
5. Insert the external monitor Microphone into the monitor jack.
6. Connect the GPS and GSM antenna to the corresponding connectors, and
find a suitable place to mount the antennas to ensure adequate signal reception.
