SURGE Series Lightning and Transient Protector
Installation Manual
ELM0100A
Page 5
F
IGURE
3-2
L
OOSENING THE CABLE GLAND
2
Remove the black cable plug from the cable gland.
3
Loosen the 4 Phillips screws on the top of the NEMA-4X enclosure. Lift the cover off.
4
Insert the cables with stripped wire ends through the cable glands and into the
enclosure. Ensure the cable sheathes are inside the enclosure.
5
Loosen the screws on the terminal with a small flat-head screwdriver.
6
Wire the leads to the terminal. Table 3-1 provides a recommended wiring scheme. It
is important to note that, aside from the shield, the order of the wires does not matter.
However, it is critical that the order of the wires is maintained on both sides of the
surge protector (for example, if the red wire is connected to 1 on the line side of the
surge protector, the red wire MUST be connected to 1 on the protected side).
T
ABLE
3-1
R
ECOMMENDED WIRING SCHEME
Protected Side
Line Side
Red
1
1
Red
Black
2
2
Black
Green
3
3
Green
White
4
4
White
Shield
SH
SH
Shield
CAUTION:
E
NSURE THE ENTIRE NUT BODY DOES NOT LOOSEN
.
L
OOSEN ONLY THE
GLAND
.
