RST DLS-35 - 10 Series, Инструкция по эксплуатации

Страница: 18 / 28

DLS–35 © Dinel, s.r.o. 18
Figure 17: Time intervals for touching the magnetic pen on the sensitive
spots for individual functions of the sensor
1. QUICK SETTING
2. BASIC SETTING
3. SETTING OF
SENSITIVITY
4. HYSTERESIS
SETTING
b) Setting the mode Replenishing the level
(If the medium level drops to its minimum level, the sensor output closes. After replenishing the
medium, when the level rises to the maximum level, the sensor outpu opens.)
If the orange LED is illuminated and the green LED is flashing, the sensor is correctly set.
If alternating flashing of the orange and green LED occurs, the sensor did not recognize
the limits for closing and opening. In this case, find out whether the minimum and maximum
levels are not set too close to one another.
-
-
3.
4.
5.
Increase the level of the measured medium in the tank up to maximum level .
Place the magnetic pen for at least 20 seconds** on the sensitive spot "– " of the sensor (un-
til both LEDs illuminate) and then remove the magnetic pen. Settings are confirmed by three
flashes of the orange LED.
Check the state of indicators:
Bring the level of the measured medium in the tank to minimum level .
Place the magnetic pen for at least 20 seconds** on the sensitive spot "+" of the sensor
until both LEDs illuminate and then remove the magnetic pen. Settings are confirmed by three
flashes of the orange LED.
1.
2.