UNPACKING AND INSPECTION INSTRUCTIONS
Unpacking the Carton
Status LED
DC Power Jack
RCA # 1
RCA # 2
Equalizer Settings
SAFETY REGULATIONS (cont’d)
GENERAL SPECIFICATIONS
OSHA (USA) OSHA Technical Manual, Section III, Chapter 5, Section V, Table
III:
5-4
“TLV’s For Ultrasound”
FDA
(USA) the FDA has assigned the following Accession Numbers to
the SpotDAP (HSS) products: 0181485 and 0191486.
FCC
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for
help.
Packaging Specifications The packaging for SpotDAP is suitable for common
parcel shipment. It meets the International Safe Transit Association Procedure
1A pre-shipment test specifications. Structures and methods utilized in this
system are patented under one or more US and International patents.
Additional US and International patents pending. US 6,606,389 US 6,011,855
US 6,577,738 US 6,466,674 US 6,229,899 US 6,108,427 US 5,889,870
US 6,584,205 US 6,359,990
Carefully remove the SpotDAP unit from the packaging carton.
Gently remove the protective bag from around the unit. Be
particularly careful not to bend or deform the front emitter
surface or allow any foreign objects to come into contact with the
emitter surface (the silver/copper foil surface behind the front
grill).
Items Included:
(1)
SpotDAP Audio Sound System unit (model # is indi
cated on the rear panel)
(1)
User’s Manual
(1)
Warranty Card
(1)
AC Power Cord
(1)
AC/DC Power Supply
Carefully inspect the device for any obvious physical damage. If
there is evidence of any damage, STOP. Do not plug the device
into AC power. Do not attempt to operate the unit. Immediately
file a damage claim with the delivery carrier. Contact RSF for repair
or replacement instructions. Retain all packing materials.
SpotDAP Unit Controls Indentification:
19
4
