Options to expand some functions of the V2359j
amp4ribbon
LED brightness
- the illumination of the pushbutton switches can be adjusted
V
- the maximum gain can be increased
LF
- the bypass filter function can be blocked for the LF
HP2
- another high pass can be activated, with a slope of -6 dB at 20 Hz
Chassis to GND
- can be interrupted when high frequency interference is caused by strong transmitter
systems
(Detailed information on these functions can be found on our homepage under downloads at
https://www.rogerschult.com/downloads.php).
Installation in an api ® 500 system
Instructions for installing the V2359j amp4ribbon filter module
Please note that electric potential differences and electrostatic discharges (ESD) can destroy your api ®
500 system and the V2359j amp4ribbon module. Please make sure to discharge any potential electrostatic
charges by touching a plumbing pipe, heating pipe or any other piece of metal connected to earth before
installing the V2359j module. Neutral electric potential is a prerequisite to any installation or
reconfiguration of electronics modules and their interconnections.
Turn off your api ® 500 rack or console and all connected devices. Remove any blank panels that might
cover the slot you have chosen for installation of the module.
Center the module between the two threaded mounting holes and evenly insert the module into the free
slot without applying brute force. Secure the V2359j module with both screws. The module is ready for
operation once the appropriate connections in the rear of the api ® box have been taken care of.
-5 -
