RS SAILING RS Tera, Руководство по монтажу

Страница: 17 / 43

5
1. Slide the Tiller into the top of the rudder stock , and attach with the self-tapping screw.
The screw is in a small plastic bag in with the tiller, be careful not to throw it away in the
packaging! Attach the tiller extension to the tiller by sliding it into the fitting and pushing
down the cap.
2. Place the rudder on the transom with the rudder - uphaul line pulled tight, so that the
rudder blade is fully up. Ensure that the tiller and the tiller extension pass under the
mainsheet bridle . To fit the rudder , simply line up the pins with the fitting on the back of the
boat, and push down until the retaining clip ‘clicks’ into place. The
rudder may be difficult
to get on at first
– all it will need is a simple wiggle from side to side whilst pushing down.
3. Shortly after launching , when you are in deep water, make sure that the white rope is
not in the cleat , pull on the black rope, and cleat . This will lower the rudder in the rudder
stock .
4. When coming ashore, un cleat the black rope, and pull the white rope tight. This will
raise the rudder .
Rudder-Retaining Clip