RS Automation AnyTouch V7 Plus Series, Руководство по эксплуатации

Страница: 8 / 20

8
Battery holder
Connector
of battery
Write down the date of
fi ve years from now.
Notes on Usage of Lithium Battery
The AnyTouch is delivered without inserting the battery connector in the battery holder on the back of
the unit. Be sure to set the battery when using the calendar function or SRAM. Without battery, the
contents in the SRAM or calendar will not be retained.
Speci fi cations
Item Speci fi cations
Battery Speci fi cation Lithium primary battery of coin type
Backup Memory SRAM 64Kbyte
Backup Period 5 years (at the temperature of 25 )
Detection of Voltage for Battery Lowering Available (internal memories allocated)
Calendar Precision
Remainder on a month
±
90 seconds (at the temperature of 25 )
Battery Mounting Procedure
Electric shock hazards
Steps 2 to 5 must be performed when the power to the V7+ unit is turned off.
1. Turn the unit off.
2. Slide the battery holder cover in the direction of the arrow as shown in the illustration below to open it.
3. Check that the battery is securely attached to the backside of the cover, and connect the battery
connector.
4. Close the battery holder cover.
5. Enter a date fi ve years from now for "Battery replacement" on the sticker on the battery holder.
6. Turn on the power to the V7+ unit and check that the battery
is correctly mounted on the Main Menu screen. When the
battery is not connected, the [SRAM/Clock] switch blinks and
the message "Battery not set" is displayed at the bottom left
corner. When the battery is correctly connected, the [SRAM/
Clock] switch goes out and the message is cleared. When the
battery voltage has dropped, the message "Brownout Battery"
is displayed. It is strongly recommended to replace the battery
immediately even it has not been passed for fi ve years.
Battery Replacement Procedure
About the battery replacement procedure, refer to "V7-BT+ (Replacement Battery) Operation Instruction" attached to the
battery 'V7-BT+'.