RS Automation AnyTouch V7 Plus Series, Руководство по эксплуатации

Страница: 5 / 20

5
E
ng
lis
h
* When the V7+ unit is attached to the mounting panel, the fi xtures and frame
grounds (FG) are connected. To prevent static electricity be sure
to connect the mounting panel to the frame ground.
3. Mount the gasket so that it will be sandwiched securely
between the unit and the mounting panel.
Mounting Angle
The unit (V7+) shall be installed within the angle of 15 to 135 degrees.
Panel cut-out hole
Fixture
V7 Plus series
Sheet metal
Mounting
hole
Dimensions of
Fixtures (unit: mm)
Displa
y
Dis
pla
y
Modular Jack (MJ1/MJ2)
This port is used for such connection as data transfer, temperature controller network, bar code reader, CREC, and V-I/O,
etc. The pin arrangement of modular jack is as follows:
MJ1/MJ2 Pin No. Signal Contents
1 +SD/RD RS-485 data (+)
2 -SD/RD RS-485 data (-)
3 +5V
Output power supply
Max. 150 mA
4 +5V
5 SG
Signal ground
6 SG
7 RD RS-232C receive data
8 SD RS-232C send data
LAN Connector (LAN)
V712i+ only
This port is used for Ethernet (10BASE-T, 100BASE-TX) connection.
Speci fi cation: comply with IEEE802.3, UDP/IP and TCP/IP supported
LAN Pin No. Signal Contents
1 TX+ Ethernet send (+)
2 TX- Ethernet send (-)
3 RX+ Ethernet receive (+)
4 NC Not used
5 NC Not used
6 RX- Ethernet receive (-)
7 NC Not used
8 NC Not used
MJ1, 2, and LAN port are modular jack 8pins. Check the name of the port to insert a cable to the
appropriate port. When using a LAN cable: For safety, do not connect for device that might have
excessive voltage to the network port.
Mounting Procedure
Mounting Procedure
1. Insert the unit into the mounting panel (max. thick: 5 mm).
Mounting
hole
2. Insert four fi xtures attached to the V7 Plus series into
the mounting holes, and tighten them with the locking
screws. (Torque: 0.5 to 0.7N m)
Mounting panel