Royalbeach RB#65620 (CREME), Инструкция по эксплуатации

Страница: 23 / 88

23
Risk of damage!
If you do not have enough moving space when assembling the
massage couch you can damage adjacent furniture and objects.
− Assemble the massage couch with a minimum clearance of 2 m on all sides.
− Do not open the massage couch by force if the support legs are stuck.
Search for and remove the cause of this failure and only then assemble the
massage couch afterwards.
1. Unpack the massage couch from the carrier bag 14.
2. Position the closed massage couch at a suitable place on the four plastic feet 2
(see step 1 in fig. C).
3. Open both closures 15 and fold the massage couch open (see step 2 in fig. C).
4. Remove all individual parts from the rubber mountings 16 and 17.
5. Completely unfold the two parts of the lying surface 1 (see step 3 in fig. C).
Thus the support legs unfold automatically in a 90° angle.
6. Lift the massage couch in the middle and place it on the support feet.
7. Make sure that the lying surface is even. If the lying surface is not yet even, adjust the
wire cables 6 and apply little pressure on the lying surface, if necessary.
8. Secure the two halves of the lying surface with the lockings 7 (see fig. D).
You have assembled the massage couch successfully and now can adjust the lying
height and the armrests, as well as attach the head and arm supports.
Setting lying height You can adjust the height of the massage couch by loosening and
adjusting the adjustment screws at the support legs.
Adjust the lying height before attaching the armrests, the head rest and
the hand rest.
1. Place the massage couch on its left side.
2. Loosen the two adjustment screws 5 at the upper support legs 4.
3. Remove the adjustment screws and the washers and put them aside.
4. Remove the upper wooden strip with the boreholes upwards from the two screws.
5. Evenly adjust the position of the support legs by placing the wooden strip with th
boreholes on the support legs so that both screws are led into one borehole each.
Both support legs must be equally extended or shortened.
6. Attach the washers to the screws.
7. Tighten the adjustment screw clockwise.
You have successfully extended / shortened the support legs of the left side.
NOTE!
USE
GB